Welcome Guest Search | Active Topics | Log In | Register

Porsche 911 Carrera customised build - pack 8 Options
Tomick
#1 Posted : 01 July 2018 10:18:32

Rank: Pro

Groups:

Joined: 24/08/2009
Posts: 44,244
Points: -6,498
The customised build continues....Cool
roymattblack
#2 Posted : 01 July 2018 10:24:48

Rank: Super-Elite

Build-Diary Medal: Build-Diary Medal of HonourPublisher Medal: Featured Build of the MonthActive Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsRed Medal: Red MedalOutstanding Build: An award for an outstanding build
Groups: Registered, Moderator, Administrators, Global Forum Support

Joined: 04/06/2011
Posts: 2,804
Points: 8,567
Location: ipswich
PACK 8

This set of parts will complete the dashboard allowing it to be fixed to the car, fit the rear side windows to the body, fit the rear engine tray and begin the assembly of the front luggage space.

Assembly of the dashboard parts is very straightforward but fitting the steering column correctly into place is made much easier by gently pushing up from underneath the floor on the locating hoop on the steering rack that the column lower pin goes into.
The dashboard can now be screwed into the car.
Here, you can test that some of the electrical functions work.

Fitting the rear engine tray is equally straightforward but if you have added any extra wiring or pipework, take care not to get it trapped under the tray.
Route and fix your additional wiring (if any) and attach the oil pipe.

The main body shell now has the rear side windows fitted.
Before doing this the body should be coloured black inside the window openings as they will show through as white once the windows are in place.
The real cars were trimmed inside just here and were not body colour.
Colouring the areas black can be done very easily by running a Sharpie around the frames.
Fit the windows as per the instructions.

The front luggage tray is assembled next, with the heater fan and hoses being painted in different shades of black and gunmetal for a bit of colour variety even though most of it will not be seen once the cover is fitted.
The rubber hoses can be made to look more authentic by sanding the plastic parts with 400 grit wet and dry.

The small tool holder is easy to fit but once in place it is almost impossible to open the recessed lid as there is no access to the edges.
This can be rectified by attaching a small tab to the lid which will project up into the boot space.
The tab here was made using a small piece of self-adhesive vinyl folded over on itself, and stuck inside the lid. A piece of sticky paper label could be used or even a piece of sticky tape.
It isn’t prototypical but it allows the tool box to be opened with ease.
roymattblack attached the following image(s):
P1015775.JPG
P1015777.JPG
P1015779.JPG
P1015780.JPG
P1015781.JPG
P1015783.JPG
P1015783.JPG
P1015785.JPG
P1015786.JPG
P1015787.JPG
P1015788.JPG
P1015789.JPG
P1015790.JPG
P1015792.JPG
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.054 seconds.
DeAgostini