Welcome Guest Search | Active Topics | Log In | Register

X axis not going to home properly Options
#1 Posted : 01 October 2018 10:59:37

Rank: Semi-Pro Level 1

Groups: Registered

Joined: 08/08/2017
Posts: 52
Points: 210
Location: basildon/thurrock
Hi everyone I have built the 3D printer and have had a few problems that I have sorted out but there is one left and for the life of me I can’t figure it out could anyone help please?

When I press the home button on z and y it goes to home no problem but when I press home on x axis it stops briefly then stops hard to explain but I have done a video here too.https://youtu.be/HcntJPMNjg0

Can you either leave a message in here or YouTube please any help will be appreciated thanks again.
#2 Posted : 01 October 2018 11:30:36

Rank: Super-Elite

Build-Diary Medal: Build-Diary Medal of HonourPublisher Medal: Article published MedalActive Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsRed Medal: Red MedalTurquoise Medal: Turquoise Medal for model making know-how contributionOutstanding Build: An award for an outstanding build
Groups: Registered, Moderator, Official Builds, Global Forum Support, Administrators

Joined: 27/09/2011
Posts: 15,169
Points: 46,054
Location: Dudley
In your video you push the X axis into position this tells me that the rods are not correctly set up here and your getting the head binding on the rods. Its not far out but still needs a tweek to get a smooth run for the head to travel correctly into that corner.
Current builds:-C57,Zero, Lamborghini Countach, Caldercraft HMS Agamemnon,Robi,R2-D2, MFH Cobra .

Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.084 seconds.